Itaste mvp questions.

Status
Not open for further replies.

knotin1

Super Member
ECF Veteran
Mar 6, 2011
398
1,106
52
here
I have the MVP 2. Couple of questions.

1) Sometimes when using the green light will blink a few times after I depress button. Anyone know why?

2) Instruction manual says holding the two buttons it will give you four numbers.
  1. Resistance of the attached load.
  2. Battery volatge
  3. puff counter
  4. last set watt or volt setting.
I only get the first two. Anyone else experiencing this?

3) What is the battery voltage? Off a fresh charge it is above 4. After using for the day it is down to 3.7. If it is 3.7, how am I able to pump the volts setting higher?

4) My second MVP 2 was charging all night, in the morning it was still lit up green, but appears to be at 4.2v. Shouldn't the green light go out when fully charged?

5) My third MVP2 went to yellow, threw it on the charger (ego cube with mvp cable) light went to green during charging. In the morning the light was out, unpluged and nothing. Completely dead.


A Tad confused here. Thanks
 
Last edited:

solace.discord

Ultra Member
ECF Veteran
Verified Member
Jun 21, 2011
2,496
11,533
Southern Maine
no expert on v2, as I've only had it for a whole 2 days, but I've had v1.5 for a while..

1) the green light would flash when I would rarely hit the cut off.. like a real looooong vape.

2) if you hold both buttons down at the same time, you see the resistance of whatever is attached and the battery voltage remaining -- if you hold down the P button, it shows the puff counter and the wattage and puts you in VW mode -- if you hold down the U button, it shows the puff counter and then the voltage and puts you in VV mode

3) as far as I know, don't worry about it.

4) I've read that some had a software glitch that the green light would stay on when charging, even after full charge.

5) click the button 3 times and see if it comes back on.
 
Status
Not open for further replies.

Users who are viewing this thread