Joye eVic

[VapDrak]

Hi Everybody,
I just joined the eVic club! My new toy came tonight and i already need your help
I could upgrade it to version 1.2 with no problems, settings are fairly easy but then i tried different attys on it and it reads everything (Vivi Nova, Chobra,Carto tank and T2) with exeption of my T3's
Ok that is not so bad, but it misfires a lot on the same atty ,it reads the resistance and when i hit the button it starts counting my "puff-seconds". That happens with all of them, fires a couple of times then... nada...then it works again... and so on! It does it on all of them.
Strange huh? I'm at a loss here, is there reports of this behavior?
Should i wiggle the contact up a bit? I dislike the idea of tempering with it on day 1, hopefully there is an easy fix that i didn't see.
Thanks for any suggestions

 

[speedjason86]

​

Hi Everybody,I just joined the eVic club! My new toy came tonight and i already need your help
I could upgrade it to version 1.2 with no problems, settings are fairly easy but then i tried different attys on it and it reads everything (Vivi Nova, Chobra,Carto tank and T2) with exeption of my T3's
Ok that is not so bad, but it misfires a lot on the same atty ,it reads the resistance and when i hit the button it starts counting my "puff-seconds". That happens with all of them, fires a couple of times then... nada...then it works again... and so on! It does it on all of them.
Strange huh? I'm at a loss here, is there reports of this behavior?
Should i wiggle the contact up a bit? I dislike the idea of tempering with it on day 1, hopefully there is an easy fix that i didn't see.
Thanks for any suggestions

you can try pulling the center post on the T3. maybe its too low due to the well is not deep enough for the ego connection.
I only use 510 connection so I've no idea what it can be.

 

[Fullknight]

I use VapeOnly BCC and Mini Vivi Nova and Kanger T3,MT3. T3 is a problem sometimes.


Sent from my iPhone using Tapatalk

 

[chadsmo]

So I've been vaping for 3 weeks today after 20 years of a pack a day, and I couldn't be happier. First week was spent on a bad 510T auto starter kit. Next two weeks were a 650 Ego Twist and a Mini Vivi. Then today, this good times showed up.

That's a Boge F16 tank with a pre punched carto in it. I know boge have had some issues, if this is a crappy carto I'd really like to know what a good one is like, cause everything about it is so much better....

I also got an 18350 battery with the soft black Ego T tube for work.

 

[kwcharlie]

Hi Everybody,
I just joined the eVic club! My new toy came tonight and i already need your help
I could upgrade it to version 1.2 with no problems, settings are fairly easy but then i tried different attys on it and it reads everything (Vivi Nova, Chobra,Carto Tank and T2) with exeption of my T3's
Ok that is not so bad, but it misfires a lot on the same atty ,it reads the resistance and when i hit the button it starts counting my "puff-seconds". That happens with all of them, fires a couple of times then... nada...then it works again... and so on! It does it on all of them.
Strange huh? I'm at a loss here, is there reports of this behavior?
Should i wiggle the contact up a bit? I dislike the idea of tempering with it on day 1, hopefully there is an easy fix that i didn't see.
Thanks for any suggestions

Just got back from Equator, took a cab from Co-Co to Quito and I didn’t work too well at 4K meters maybe your eVic is having the same problems, I wasn’t 100% in Quito either but still eating my soup with popcorn .

Seriously any chance it’s in auto?

 

[logitech80]

Just got this haven't used it yet.. Hope this is good.. Mixed reviews on evic vs vamo..

 

[BigPapaITT]

set your overheat warning temp higher. your body temp is around 98 so you can set off the warning just by holding it long enough.

Thanks for the quick response. Any suggestion on what would be considered a safe temp setting. I am only 5 weeks into vaping and would rather not experience any of the battery failures I have heard about.

 

[speedjason86]

I set mine at 40C just a bit over body temperature.
then again the sensor is only inside the head not on the battery so its not that accurate either.

 

[zipflint]

Just out of curiosty, since I don't have mine yet....does it have a default setting? Or is the question whether or not that default setting is too low and causing it to shut off when it doesn't need to?

edit:
by "default setting" I'm referring to the overheating warning

 

[VapDrak]

​


you can try pulling the center post on the T3. maybe its too low due to the well is not deep enough for the ego connection.
I only use 510 connection so I've no idea what it can be.

Just got back from Equator, took a cab from Co-Co to Quito and I didn’t work too well at 4K meters maybe your eVic is having the same problems, I wasn’t 100% in Quito either but still eating my soup with popcorn .

Seriously any chance it’s in auto?

Thanks Guys,
T3 is a problem but at least today i did'nt have the misfiring problems on the same atty. Worked perfect all day.
So it's oficial: I love my eVic!

@Kwcharlie if you come back to Ecuador send me a message, i would gladly show you around!

 

[crxess]

T3 - Kanger had an issue of setting the center pin to high on some. Possibly a single machine out of calibration. Pull the pin down slightly and it will work fine.
I have a dozen Kangers working fine on (2) Different eVic's

 

[chadsmo]

So this is the first full day I've had my evic and i have the system off timer set to 30min. It hasn't been off once when I've picked it up to vape it today lol.

 

[Jfp3]

After the 1.2 upgrade and the bOd by Leo I really haven't put my eVic down LOVE it!

Sent from my iPad using Tapatalk HD

 

[chadsmo]

After the 1.2 upgrade and the bOd by Leo I really haven't put my eVic down LOVE it!

Sent from my iPad using Tapatalk HD

What have you got on top, looks sexy.

 

[fogmachineroy]

Same experience here. 18350 battery dosent last me but like 2 hours of serious vaping, and if I turn it off overnight the battery will still drain.

Same here, I was wonder what's the highest mah 18350 battery out there safe to use with our evics

 

[fogmachineroy]

What have you got on top, looks sexy.

I think that's a aga-t+ if I'm not mistaken

 

[Jfp3]

Originally Posted by chadsmo
What have you got on top, looks sexy.

I think that's a aga-t+ if I'm not mistaken

Yes it is an AGA-T+


Sent from my iPad using Tapatalk HD

 

[Big Screen D]

Anyone using 18350 Li ion protected batteries with the Evic?

I currently use AW IMR 18350's, but would like to find some batteries in the 1200 mAh range. Not sure if there is a enough room for a 18350 protected.

 

[Lhartman89]

I am using UltraFire unprotected 1200 mAh button tops in it.

 

[Jfp3]

I am using UltraFire unprotected 1200 mAh button tops in it.

So am I.


Sent from my iPad using Tapatalk HD