Joye stick v3 not producing vapor

Status
Not open for further replies.

JZeFF

Full Member
Jul 24, 2011
21
0
Ohio
Hey guys!

I ordered a Joye stick v3 from heavens-gifts about 2 weeks ago and i just got it today...
I put the battery in, put the cart in the atty, and plugged the stick into the usb pass-through charger..
I cant seem to get any hit off of it at all... i get some smoke, but rarely any...
I chose the "USA mix" as my flavor in the carts.

I also ordered some other e-liquids.. i tried dripping 3 drops of 18mg menthol onto the atty, and that didn't help either..
I seem to be getting the taste, but no smoke.

Also, when i take a drag it is making a wet suction noise, is this normal?
I had a blu e-cig a few months ago, and that was producing more smoke than this one is :(
Do i need to suck hard, suck slow, suck fast?? (<< that is a serious question, lol)... i dont get what the deal is here.
 
Last edited:

JZeFF

Full Member
Jul 24, 2011
21
0
Ohio
I blew out the atty, dripped 3 drips onto the bridge, and tried taking longer slower drags... seems to be working alot better now!

I have a question though... when the carts start to run dry do i just add drips till its well saturated again?

Also a while ago i ordered the "blue foam" for my blu-cig... would it be a good idea for me to replace the material inside the Joye carts with the blue foam? (the blue foam was never used)
 
Last edited:

tmcase

ECF Guru
ECF Veteran
Verified Member
Apr 20, 2011
20,862
54,652
The blue foam is not designed for any particular thread (510, 901, 808). It can be used in any cart.
I'm not familiar with the t-shaped blue foam. I get it in sheets and cut to fit. If one is lose, you might have to add more. You don't want any juice pouring out of the cart when you turn it upside down.
It won't hurt anything to leave the charger plugged in when it's not charging.
What I do when filling carts is fill the empty cart (without the blue foam in it) half full, then put the blue foam in and add drops until the foam is completely soaked but not pooling on top. It should look a little slushy. If you add too much just dab it with a paper towel until it looks slushy.
The blue foam is easy to rinse out so no you don't need to dedicate a cart to a single flavor. Just rinse under hot water then dry real good with a paper towel and reuse. I hope you are talking about cartridges and no cartomizers.
 
Status
Not open for further replies.

Users who are viewing this thread