joye510 issues with cart?

Status
Not open for further replies.

seven

Super Member
ECF Veteran
Verified Member
Mar 28, 2009
637
23
Fringe HQ Chicago
ok i recieved the joye510 kit last wed and it is my 2nd starter kit. at first this was producing great vapor, but now it seems to be hard to inhale and get the atomozer to produce vapor. i have switched to a new cart but still the same thing. so i blew into the other end of the atomizer to blow out the extra juice and then topped off the cart and still the same issue. finally i took out the fiber in the cart and dripped straight into the atomizer and that worked, but the atomizer was hot as hell. is the atomizer shot?
 
I also have the joye510 aka yeti --- its great when its working well --- my first atomizer lasted about 10 days, then I replaced with the spare and that lasted less than 24 hrs --luckly had purchased a xtra at the time I ordered. anyway lost 2 atomizers with about 3 days use between the 2 -----bout another kit that should be here tomorrow
maybe I was unlucky withe the atomizers I hope so because I like the yeti and the whole e cig deal but certainly have spent way more cash than I would have if I stuck with buglar handrolleds taxes or not --between the juices, kits etc
 
From what I understand, soaking the atomizer in pepsi and then blowing it out will bring it back to life. One has to rinse and dry it thoroughly, of course, before using it again.

I'm a new vapor since april 1 --I have a feeling these atomizers are completely dead --not heating up in the slightest --tried boiling one for a few mins and messed with it the next day after blowing it out ---nothing.

In regard to the OP's problem with the leaky carts from my limited experince with the 510 I've found that by not overfilling the cart resulted in best results for me. I just top off and rarely pull the stuffing out and fill that way. If I have overfilled and it runs down the sides of the cart into the holes leading to intake hole then that results in a mouthful of e liquid.
 
Status
Not open for further replies.

Users who are viewing this thread