Joyetech 510 - do they suck? Why?
- Thread starter UncLeJunkLe
- Start date
- th_trl_thread_readers 0
- Status
A few years back Joyetech, Wismec and Eleaf, which are just different brands of the same company btw, tend to press fit their 510 from the top. If you wanted to remove the top cap of an RDA for example, it was possible to rip out the mod's whole 510.
On top of that, atties with a slightly longer 510 pin would not sit flush, because the mod's 510 did not have enough travel. But it was even possible that screwing on such an atty could cause the mod's 510 to collapse or get stuck behind the threading, which could render the mod useless as well.
As far as I know those issues have already been addressed quite a while ago, so as far as I remember correctly, all of their 510s since the Evic Primo 2.0 should be fine.
On top of that, atties with a slightly longer 510 pin would not sit flush, because the mod's 510 did not have enough travel. But it was even possible that screwing on such an atty could cause the mod's 510 to collapse or get stuck behind the threading, which could render the mod useless as well.
As far as I know those issues have already been addressed quite a while ago, so as far as I remember correctly, all of their 510s since the Evic Primo 2.0 should be fine.
- Status
