Hey whats up new to board. I Just bought the joyetech ego one. I'm fairly new to vaping been vaping for a couple months. My question is that the liquid keeps coming out of the air flow slot. Is this normal for this device? I'm not over filling it. But after I hit it a couple times, the juice starts coming out. Is the device faulty? Any help would be greatly appreciated. Thanks
Joyetech eGo one question
- Thread starter Mikelo4ever
- Start date
- th_trl_thread_readers 0
- Status
You probably want to be using liquid thats 50/50 pg to vg so it's viscosity is high enough not not flow past the wicking. More vg usually means higher viscosity. Another thing to try is swaping out the coil and see if that stops the leaking. Sometimes a coil head isn't wicked correctly when it's made.
I've only had mine a couple of days but have noticed when you take the head off the atty will come out still inside the head instead of staying with the seating. It unscrews at the same time the head does.You have to screw the atty back into the base before you re-install the head. I don't have juice coming out of the airflow but I do have vapor coming out that area. The issue I'm having is the head sits at a slight angle to the air flow ring which may be contributing to the atty unscrewing each time. Does yours sit flush to the airflow ring?
Now mine is doing the same thing. It runs fine for a bit then floods. I really like this thing but it's becoming a real PITA.
Pressure differential created between your mouth and the atmosphere could be too high. You could compensate for this by opening the airflow control a bit until you get the results you desire.
YMMV as usual.
YMMV as usual.
I assume your talking about gurgling. I get this sometimes when I'm drawing to heavily especially on the larger 3ml Aspire tank. My quick fix is gently run a pipe cleaner down the tip to soak up excess juice. Don't poke the coil, also check that every thing is tight. Hope you figure it out.
I haven't had this issue with mine so far. Is it possible that the o-ring on the coil is not sealing?
Sounds like a leaky coil. Try putting a new coil in, and if this doesn't work try a thicker (higher vg) juice.
- Status
Similar threads
