-- was going to add this at the end, but to try and avoid the 'nobody uses carts/get carto's' type stuff, I'm ordering some Boge cartos TONIGHT. --
Been vaping a menthol for a week - same cart and atty (no cleaning of either, but no other juices were used on the two. I did take the atty off, and let drain on a tissue every night). Last night, getting towards the end of the 5ml bottle, everything started seaming watery, and the cart was gurgling.
So, i disassembled the mouth end of the cart (510) cleaned all the innards of liquid (endcap, baffle) and blew it out (but left the juice/filler alone). Checked the atty, and it was burning just fine, and wasn't flooded (dripped a different liquid, and it was fine). Reassembled everything, and after two minutes, it was still watery tasting and the cart had excess liquid by the mouth end again.
I KNOW the cart wasn't overfilled - when I reassembled, it was a little less than full.
So, I'm trying to figure out what was going on to avoid it in the future. I've only come up with two possibilities, and would like some input.
A) I didn't really shake the juice much, so maybe there was some separation, and the last little bit was just bad.
B) After going thru about 5ml on the same cart over 1 week, without cleaning it or using a new one, the constant exposure to vapor left excess moisture in the filler.
Been vaping a menthol for a week - same cart and atty (no cleaning of either, but no other juices were used on the two. I did take the atty off, and let drain on a tissue every night). Last night, getting towards the end of the 5ml bottle, everything started seaming watery, and the cart was gurgling.
So, i disassembled the mouth end of the cart (510) cleaned all the innards of liquid (endcap, baffle) and blew it out (but left the juice/filler alone). Checked the atty, and it was burning just fine, and wasn't flooded (dripped a different liquid, and it was fine). Reassembled everything, and after two minutes, it was still watery tasting and the cart had excess liquid by the mouth end again.
I KNOW the cart wasn't overfilled - when I reassembled, it was a little less than full.
So, I'm trying to figure out what was going on to avoid it in the future. I've only come up with two possibilities, and would like some input.
A) I didn't really shake the juice much, so maybe there was some separation, and the last little bit was just bad.
B) After going thru about 5ml on the same cart over 1 week, without cleaning it or using a new one, the constant exposure to vapor left excess moisture in the filler.