Juice feeding problems... help

[Trox.Shawn]

So, I was cleaning my mod this morning and now, for some reason, the juice isn't squonking correctly... I'm not sure why, but I have to push REALLY hard to get barley any juice into my RM2. I made sure the tube was on the post well, and took the o-rings out of the cap and reinserted them but still nothing. What else do I need to look for?

 

[4nic8]

Loosen the bottle a little from the cap and with the door off and cap off (or at least the drip tip out) take a look and see how it's feeding then. Sounds like the bottle might be screwed on too tight.

 

[super_X_drifter]

Have you already cut an inverted V into the bottom of the tube to keep it from suctioning to the bottle?

 

[Trox.Shawn]

That wasn't the issue, but I just tried something new in my panic and snipped a little of the tube at the top. It works now. It was like the tube loosened and wasn't sealing correctly.

Thanks

 

[Chowderhead1972]

Confused.... You never mention leakage. If that were the problem it would be dumping juice onto the bottle. I believe super x had it right. When you put it back together the bottom of the hose came up off the bottom of the bottle, it will go back. Trim a slash cut on the bottom end of the hose and you issues will be over for good.

 

[jifjifjif]

So, I was cleaning my mod this morning and now, for some reason, the juice isn't squonking correctly... I'm not sure why, but I have to push REALLY hard to get barley any juice into my RM2. I made sure the tube was on the post well, and took the o-rings out of the cap and reinserted them but still nothing. What else do I need to look for?

Could have been the barley that was plugging up the juice hole too.

 

[Chowderhead1972]

Freeze! The grammar and spellin' police have arrived... Were are all safe once again.

 

[el_lou]

Could have been the barley that was plugging up the juice hole too.

I see what you did there.