Just built a micro coil 2.8 ohms

[Lilag]

Ok so I just built my first micro coil for a kanger t3s it's reading 2.8 ohms 6 wraps is that too high ?

 

[Dan GSR]

guage wire?
inner diameter?

 

[WorksForMe]

I shoot for 2 ohms on my Protank coils. If they’re a little higher, I just raise the voltage on my mod a little. Five wraps works best for me.

J.R.

 

[porkchopbun]

Hi
Could you upload picture of the coil, it also depends on gauge wire you were using? What was on the label 34,32 Gauge?

When I was rebuilding Kanger coils, my sweet spot was 1.6 to 2.4....

You can also use this as reference on wrapping coils
Coil wrapping | Steam Engine | free vaping calculators

 

[Lilag]

Oh sorry it was with 32 Guage wire

 

[Wolfenstark]

Diameter ? 2.5 mm perhaps ?

5 wraps at 2mm with 32 will get 2Ω depending on leg length.

 

[Dan GSR]

32 gauge is pretty thin
thicker wire will allow lower ohms

 

[porkchopbun]

Here is a vid on the rebuild, for me 2.8 would of been too high, see if any these builds resembles yours



I would shoot for around 1.6 to 2.2 ohm on those coils.