Just built my first parallel coil!

[Citizen]

Yeah, so I did it! Let me know what you think. Using a deck and top that was donated to me (Tobe I think). I machined the body of the rda out of 303 SS. This thing runs hot at .5 but damn is she tasty. It's way different than the dual coil on my stillare at .8. Could have done better on the holes. Should have used a carbide endmill instead of HSS but I was excited. Flavor is awesome. I went with two .065 holes as opposed to the three .050" air holes from the original. Let me know if you like the design, I made schems in solidworks. PM and I'll gladly send.

 

[jswag5]

parallel coils are my go to flavor coils anymore, run them in almost everything from about 1 ohm in my rm2 down to .2 ohm in my plumeveil

 

[Citizen]

I've had this mod for a day. Panzer blackhawk clone, Sony VTC3 18650s and I love It! The two RDA's put out completely different vapor with the builds. I like the parallel but it cooks through juice so quick. Pretty damn hawt too! What I would like to do, would be to incorporate either a dual coil or parallel coil into my ehpro kayfun lite clone for the "away from home all day" days... Bam, I have a tank that I don't have to fill while I'm driving on the thruway for an hour. Any suggestions? My Kayfun was fine with a regular old micro while it sat on my MVP but now that I have the Panzer...I think I can do better. Any input would be great!

 

[jswag5]

for a kayfun running a 30 gauge parallel with approx 6 wraps will put you at approx .5 ohms at 1.5 mm dia, 32 gauge 7 wraps 1.5mm parallel will be close to 1 ohm. both these coils will be tough to fit and wick but is doable