Just got a mech mod
- Thread starter infamous718
- Start date
- th_trl_thread_readers 0
- Status
what pg/vg juice ratio do you use and atomizer? the more vg, the more clouds, also what kind of wire do you use? if you're using a 28 gauge or higher I believe you wont get a lot of vapor
Could be a thousand reasons pg/vg levels, airflow, the type of build, the wicking or even the rda/rba/tank your using show us some pics of the setup maybe we can be more helpful and narrow it down for you
If the mod has been properly cleaned, your battery is charged...it's almost gotta be the build. I wrap with 28 guage wire and get massive vapor production , even with my higher wraps at 1.4 ohms. In my drippers I wrap between 0.7 - 0.9 sub-ohm, for Kayfuns/Prometheous/Krakens between 1.1 and 1.4 ohms. I get excellent vapor production with 28 Guage kanthal. So I doubt that's the problem, I'd wrap another coil and try it again. Though VG is supposed to give better vapor production, I have several 70/40pg-vg and 60/40pg-vg that give up more than enough vapor. Good luck.
This.
Check everything for connectivity issues, tighten screws etc.
What's your build?
.6 ohms and good airflow will get ya clouds.
I can change the weather with my single coil IGO L (drilled air hole).
- Status
