Just got an Evic and some issues / questions

[Ankah]

i have searched google regarding eVic no draw and didnt find anything helpful so far

as title said i just got an eVic comming from a eGo-Twist and would like to use the eVic with my Protank 2 using the 2.5 heads i have.
the issue i am having is there is almost no draw or hit, when i put it back on the eGo-Twist it hits and draws fine.
am i doing something wrong ? i have read of issues with the Protank 2 Kranger heads being spotty which is why i tested the head/tank with my eGo
currently my eGo-Twist is set around 3.7 or so ( 1 1/2 notches below 4 )


*Edit - yes its turned on, yes i updated using the Software, and have even factory reset the device. have also tried different voltage settings on the eVic

 

[Dakota Jim]

When you say "no draw" do you mean you cannot get air flow? or just no vapor?

no air flow - do not screw the tank down so tight, you may be sealing up the little holes in the tank threads that provide the air flow

no vapor = no power to head - carefully pry the center pin on your tank out just a tiny, tiny little bit (careful not to pull the pin all the way out - then you need to replace the head) DO NOT pry on the positive pin on the EVIC

the no power to head is common on mods and you will get used to pulling the pin a little whenever you change heads

oh, and welcome to the ECF

 

[Ankah]

i want to say both, the draw using it on my eGo seems easier, like using a straw with a Soda vs a Milkshake. the vapor is the same, there is more vapor using the eGo

as far as tight, i have tried loosening it some where it is no longer finger tight and i can move it back and forth a bit.

i can try the power to the head pry thing

When you say "no draw" do you mean you cannot get air flow? or just no vapor?

no air flow - do not screw the tank down so tight, you may be sealing up the little holes in the tank threads that provide the air flow

no vapor = no power to head - carefully pry the center pin on your tank out just a tiny, tiny little bit (careful not to pull the pin all the way out - then you need to replace the head) DO NOT pry on the positive pin on the EVIC

the no power to head is common on mods and you will get used to pulling the pin a little whenever you change heads

oh, and welcome to the ECF

 

[Ankah]

when you say tank, you mean the ProTank2 ?

no vapor = no power to head - carefully pry the center pin on your tank out just a

 

[Ankah]

ok update, i was in process of pulling out the atomizer base a bit when it droped out of hand and i was able to get it before it fell down the sink drain ( it wedged between the drain stopper and drain.

suffice to say i wasnt goign to use it after that so i just swaped heads.

after i put on the new attomizer head i looked at the base and it was jutting out past the threads, which th eprevious head wasnt.

i just tried it on the evic and it works fine, so im going to divy it to a faulty head ( its easier that way )

seems in the future because the Power post of the Ego-Twist and eVic are diffrent lengths i will have to get a tank specific for each device.

i thank everybody for their help and i look foreward to hitting on my eVic