Just got my new AC9 1.3. I cant for the life of me take it apart? Any advice? Am i doing something wrong?

[maf2k8]

Ok either i am just having a brain fart today or this new AC9 1.3 i just got from Vapinaze is glue together or was tightened by king kong!

I went to disassemble it to clean it as usual with new stuff, get the top cap off, unscrew the long center post/screw and then go to screw off the top cap/bottom cap to get the tank and caps off to wash and IT WILL NOT EVEN MOVE! i even tried soaking it in hot water and nothing!

I am NOT going to take pliers to it, thats for sure! Its like this thing its glued together? am i missing something here? I am not weak by any means but this thing is locked on!

Anyone ever have this issue? Any advice?

 

[Jazzi Mike]

I have been having that problem with all of my rebuildable atomizers. Luckily, I haven't spent $120 on them, so I'm usually not afraid to break them. Good luck.

 

[maf2k8]

I had a issue with the negative screw being to tight on one of my RSST before, It was so tight that i had to nearly strip the head of the screw to get it to loosen up.

What are these people using to tighten things today? Good lord!

 

[Rule62]

Try putting it in the freezer for 1/2 hour or so. Then try it.

 

[maf2k8]

I grabbed a pair of rubber gloves, that way it could grip the stainless without any slippage and BAM! loosened right up! Nice!

 

[MCMLXX]

I use 2 screw drivers put it to fill-hole and another in wick-hole. Grape end of both screw driver and bottom of ac9 then twist... Done.