Just playin' around...

[Worldgod]

Thought I'd share...

So I took my failed bottom feed 3.7v box and a no cable 510 USB charger and threw this together.

I just popped the case on the charger and took out the guts then took the 510 battery connector off the charger, ran - wire from led and + from switch in. I also added a drip catch (#10 finishing washer)...and secured my switch and atty connector with epoxy putty. Added a stray USB cap for when not being charged.

I wasn't sure if would work for charging but it does...yay. (Obviously pretty darn slow...only around 200mAh).

I can also charge and vape at the same time with it. Well, it charges when I'm not vaping while it is plugged in. Not exactly a PT cause the charger doesn't put out enough amps to power the unit w/o the battery in there (yea, I had to try).

All in all it turned out like I planned and works great with LR atty. Would have been better to replace the full size male USB connector with a female micro or something so it wouldn't stick out but I used what I had...hehe and it gave me something to do with a couple hours the other night anyways.

Finished




Red is charging...


Green is charged...


Well...enough from me...thanks for lookin' all...

---WG

 

[VpnDrgn]

Nice recycling, that avatar is creeping me out though.

 

[Worldgod]

Glad ya like it and thanks Vpn.

 

[TomCatt]

Cool work WG! (and I like the avatar )

 

[Worldgod]

hehe...ty Tom

 

[drewk302]

nice job. I have a few of those transparent boxes and everytime I drill or cut it, they snap on me. I try to be gentle....I dunno. I do like the look of them though.

 

[Worldgod]

Thanks Drew...It is the only clear box I have but have not had any issues...musta been lucky