k100+igo-l, recoiled but wont fire

[bakry]

Hi guys,

during the day, my k100 was working normally... bought myself some 28awg khantal and some wick, thinking id start practicing recoiling..

got home, took the coil/wick out of the atty (still attached to the k100), recoiled, put it back in, pressed the firing button and...
nada..nothing happened..

whats going on? I checked in case the khantal is broken, still attached, i recoiled another coil/wick..still nothing...

some say it might b that the 510 pin on the pv is sunken in, i tried to pry it loose but still nothing..

plz help

thank you

 

[Renzuli]

Welcome , but you need to check , and make sure , none of the coils are touching each other , and did you season the mesh , first , before wrapping the coil . Not doing this , could cause a direct short , No fire . If you don't have one , get a multi-meter to check your devices . Good Luck . Oh , and there are alot of video's on YouTube , if you can get that , where you live . Check out Igetcha69 . As an update , the Rebuildable your using is using a silica type wick , so no oxidizing / seasoning . But still could be a short somewhere , or the contact plate is too low . Again , a good reason to have a muli-meter , to check your coil , before use .

 

[bakry]

fixed! its the batt...my cheap charger that came with the k100 didnt charge properly

I got myself 2 new batts n a decent charger