K100 problems

[Drmiller98]

I just got a k100 mod from my local vape shop, and it worked fine for a while... Except the battery charger doesn't work. Any reasons you guys can think of. Also, the cartomizer stopper working. It was working fine, until i took it off and out it on a smaller battery, then i put it back on and it doesn't even make a noise, and i put my protank on it and it works fine with the k100. And then i put the carto back on the little battery and it works on there but just not the k100...? Any suggestions???

 

[penmoid]

The cartomizer is probably not making contact with the firing pin on the K100. K100s have a semi-floating center pin which may not be hitting your carto properly. Try tightening up the lower section of the K100 slightly.

The battery charger could be a number of things. If you have more than one battery and it doesn't charge either of them, it probably just needs to be replaced.

 

[reytran]

You might just need to buy a new one

 

[jefsview]

Which battery charger do you have? If it's one from a k100 KIT, then you are better off without it and need to purchase a better one. Hopefully you have some safe chemistry batteries and/or a fuse as well.

 

[sperlinvape81]

Your mod is not regulated, which means that once the battery goes dead, there is no bringing it back. When your vapor production drops off, put the battery on the charger. Your mod does not have a shut off when the battery is drained, so pay close attention to your vapor.

 

[Drmiller98]

Its still does nothing, even when I tighten/loosen the bottom section. And the k100 works with the protank on it, just not the "stock" cart. And ill just get a new charger