So ive had this k100 for a few days now, and its been working great. Then all of a sudden it stopped working. So i charged the battery and put the carto back on, and still nothing, not even a sizzle. I put that carto on my ego t battery and it worked fine. So then i put my protank 2 on the k100 battery and it worked fine. Kinda suspicious huh? Everything works except when i put the "stock" carto on the k100 battery. I tried messing with the tightness of the bottom section and etc. still nothing, even tried a new carto... Nothing. Any suggestions?
K100 problems
- Thread starter Drmiller98
- Start date
- th_trl_thread_readers 0
- Status
Just an idea, but are the contacts on the K100 clean? When contacts are dirty, I've had situations where some attys will work and some won't.
The only other thing I can think of (in my fairly limited experience) is the center post being too low for the cartos...I haven't personally tried to adjust it on my K100, but I just read somewhere that it will "float" a little bit, even if not considered fully "floatable".
I have a K101, and have read that the contact does it pushed down from some toppers.
I believe that if you use a paperclip or a precision flat head you can gently pull it up.
VERY carefully, I might add.
I believe that if you use a paperclip or a precision flat head you can gently pull it up.
VERY carefully, I might add.
A simple o-ring insertion under the center pin is required. You may have screwed the carto too far onto the K100 and pushed the center pin down a touch too far for that particular carto.
A quick fix if you have a hole punch handy.. and a few old evod/T3/T3S/protank or similar Bottom coil devices around. Take the silicon top seal (the cup with a hole in it..) and "punch" it out as centered as you can. Slip this under the center pin and you're good to go!
A quick fix if you have a hole punch handy.. and a few old evod/T3/T3S/protank or similar Bottom coil devices around. Take the silicon top seal (the cup with a hole in it..) and "punch" it out as centered as you can. Slip this under the center pin and you're good to go!
- Status
Similar threads
