I own Kanger's M3 and T2 (both top coils) and I like them both very much. That little M3 is amazing for a 1.0mL clearo. However, Kanger's bottom coil clearo is junk. Some call it a T0. It's hard to believe Kanger can offer such nice products like the T2 and M3 and then turn around and offer this trash. On one hand, it's nice that you don't have to turn this thing upside down and fill it up with a syringe. On the other hand, I don't think their process for filling their bottom coil is any better. It has a plunger you have to push in and just a little tiny passage to get the fluid into. It's automatic you will make a mess. I'd rather have the syringe method. But worse, I vaped a full tank then filled it again. Later, I noticed I filled it a little high (it's hard to control the fill). So I went to open it to take a little out and the mouthpiece was welded to the collar it screws in. I had to get two pair of pliers and crank the thing off. Well, that made a mess of the thing. I put it back together (barely) but it has no suction left. I have a piece of scotch tape wrapped around it to seal the air from getting in. It's too bad because the performance of this bottom coil was excellent. It vaped great. Nice clean hits, consistent, lots of flavor, etc. It's just built like a total piece of crap. Hard to believe Kanger puts this junk out. My guess is someone else builds it and they put their name on it. Try again Kanger. Meanwhile, I will be trying other bottom coils starting with a Phoenix.
