Quick question... I just received this subtank as my first rta and I'm very excited about building it... So far I have 28 gauge kanthal and organic cotton... Could you tell me how many mm the blue screw driver is? And what do you recommend if that's too small... Because it seems too small... How many wraps on what diameter drill bit? How many times should I dry burn it? Any other advice would be greatly appreciated... Thanks in advance!!!!
kanger subtank mini rebuild
- Thread starter MeganC
- Start date
- th_trl_thread_readers 0
- Status
I run my KFL and regular sub rebuild with a 5/32 drill bit and 7 wraps 28 and comes out at 1.2-1.3 and cotton wick. Works great and my standard build.
Hi, I use a 2mm mini screwdriver with 6 wraps with Japanese cotton and average .9 ohms.
For 28 gauge, I'll normally use 4 wraps on 2.5 mm for a .8 Ohm build, vapes great at 20 watts. I think the screwdriver is around 1.5mm, which is way too small. You'd get dry hits pretty quick.
Take a look at steam engine (great online calculator) Coil wrapping | Steam Engine | free vaping calculators Also do you have an ohm meter? If not you should definitely get one, and get familiar with ohm law, you want to build safe. There are tons of tutorials on YouTube also if you care to take a look, good luck with your first build!
- Status
Similar threads
