Kanger Turbo Rebuild - Help!

[Cote]

I am a quite good at rebuilding other tanks including Kangers but this turbo has me stumped. I am useless at ohms. I am attempting to redo the coils but am having difficulty getting the proper ohms per coil. I plan to put single coils in each casing instead of dual. I can use either wick, cotton or Japanese cotton. I like to use 32 gauge Kanthal. If another gauge is better I will definately try it. My question (plea) is this: How many wraps per coil so that when I put both coils back into the Turbo they work? I like to vape a coil about 2.0 ohms. Sorry but math is not my strong point. My mods are OK but can't afford a new ones. I want to make these work: Innokin - iTaste 134, VTR and CoolFire2. Any assistance is appreciated.

 

[eyerhere]

I am not up on that system but here is a link that will help
www.steam-engine.org
Do you have a way to check the ohms of your finished coils?
Counting wraps is not acceptable. If ther is a short you wont know till it goes BOOM!

 

[Cote]

Yes I have an ohms checker. I just need to know at which ohm I need to have on each coil so they work together and has the end result of 2 ohms.

 

[vaperature]

I think each would have to be at 4 ohms if together you want them to produce 2 ohms. Does that make sense?

 

[Cote]

Perfect sense. Thank you. Just one question please... is a higher ohm hotter or colder? Is 4.0 hotter or colder than 1.0? I was under the impression that higher number is colder than a lower number. I hope I am right.

 

[classwife]

Moved to Clearomizers from the Modding Forum - Tank Mods

Forum: Modding Forum
The home of modders - the builders or modifiers of custom ecigs.