kangertech 0.8ohm coils junk

[subiesltvb]

ok listen carefully kanger products good stuff. I love the aerotank V1s I have 3 of them using 1.5 ohm coils you cant go wrong. I use them on both my mechs; I have a smoktech 18650 turbo and an authentic paragon carbon fiber midnight edition. I use them on my MVP 2.0 except one the base threads are different want even touch the thread walls on MVP. I have T3d and mini unitank. I have used the 1.2 ohm coils too on my smok turbo mod. but here recently I bought a cloupor T5 and a blue carbon fiber edition IPV2 50 watt box. I have 3 RBA attys 18650 blue metal tobh, a silver plume veil, and a 28.5 silver tobh (I guess when I say silver I should say stainless steel). I run 0.8 on my attys; so I bought some .8 ohm coils for my aerotank and they want even work; plus my aerotank with a 1.5 ohm want even register on my ipv2. my nautilus works great on it. what is the difference between a .8 rba and a .8 bdc?

 

[ccCapt]

The Kanger 0.8 ohm coils work fine for me in either an AeroTank or T3D on my 900mah SmokTech VV battery and also work fine on my 1600mah Vision Spinner 2. The issue I have with them is after 2 or 3 tanks, the wick starts to break apart and pieces of it start to come out of the top holes on the coil.

 

[USMCotaku]

Define won't work. Are they just not firing? Some mods positive contact doesn't play well with the aerotank. My Hana v3 reads one of my aerotanks as shorted if I tighten it just a hair too much. With your tank assembled, look at the 510 threading, ideally the positive pin will stick out slightly, if it isn't, you may be getting a short there

 

[subiesltvb]

maybe I clean my threads regularly and try to watch as I tighten the tank down but its happen to me before. so I will have to double check for a short.

 

[ProjektMayhem]

My Kanger Aerotank with .8 coils works great on my iPV 2. Is the positive pin high enough to make contact with the tank pin? Does it say check atomizer when you try to fire it?