Kayfun alternative coil attachment

[derogg]

Has anyone used the coil attachment holes on the side of the blocks instead of the ones on top? I'm not sure I understand what kind of setup they would be used for. If you have a picture of your setup even better. Thanks
- Dirk

 

[State O' Flux]

They allow for the use of ribbon wire or dual coils (or both)... although the coil(s) still need to be, at least partially aligned with the air port.

 

[Joka]

I never used them, so does it cause difficulty having to work with long legs from underneath? I'd like to try a dual coil on my kayfun, but I Almost feel it doesn't even need such force from a small chamber lol

Sent from my SCH-I545 using Tapatalk

 

[lamarrk]

It's much simpler to tie off the coil legs under the screw heads which helps in getting the coil centered over the air hole.

I did my first coil using the side holes and didn't like it, but I also used silica for my wick.

I'm using cotton now. Very simple to remove the cotton wick and dry burn to clean. Install new cotton, wet thoroughly, put it back together, fill and vape.

 

[Nate Rager]

The coil I had in my russian (almost identical deck) before I put the current double barrel coil in was a braided 3 strand 28 gauge. I used the side holes. Just had longer legs and bent them in almost a u shape. One side of the u's went into the holes the other continued into the coil. It worked well and was fairly easy to build.