Kayfun Chimeny Coil done.

[Desecrate]

Built a chimney coil for the kayfun Lite plus v2. Coil is directly on the air hole, and vape comes directly up the chimney. Hits hard and flavor insane if done right, some juices don't like it as much and its tricky to wick. Have to wick around it vs. inside the coil. Anyhow was bored figured I'd show my kinda decent kayfun chimney coil build pics. 28g at 1.4ohmz

 

[Susan~S]

Do you have a picture of the build with the cotton (before you added eliquid)? What flavors of eliquid did you like using this build?

 

[Desecrate]

The wick on the walls moved during the pic some reason so it un tightened but you get the idea how the vapor goes straight UP the chimeny. Kinda like a candle in a way but extreme candle

 

[Susan~S]

Thank you! I may have to try this.

Have you tried the cotton nest build? I haven't but it's on my list. Building Kayfun Lite Nano - Cotton Nest PT1

 

[Desecrate]

Thank you! I may have to try this.

Have you tried the cotton nest build? I haven't but it's on my list. Building Kayfun Lite Nano - Cotton Nest PT1

That is cotton, I only use cotton.

 

[Desecrate]

Want a good tutorial on it, look up RIP Tripper Chimney kayfun in youtube search.

 

[Desecrate]

I wick differently than he does, but he can show you the coil. The idea he shows is right on par with the cotton being bow tied around, But I put just enough to not add any extra. and he shows you pressing it against the walls and that's what I do as well. You want to cover as much surface area on the coil as possible tight, but not to tight just snug enough, then when done look at the top and cotton blocking the top of the coil move it out, also look down the coil see if there is cotton coming from the bottom covering the air hole, and you can just get a small screw driver in side the coil twist it around to clear it. So its just air hole directly up the coil and the coil shoots the vape directly up the kayfun chimeny, some juices like super fruity like citrus stuff going to hit your throat like a truck. Anything around 1.3 - 1.5 or so, is what I do in ohmz

 

[Desecrate]

I've been trying to master this one, but its a pain in the ....ing ... because how small the post is and moving around the leeds and lining up everything perfect. Its super tricky. Some make it look easy, but once you start doing it, its trial and error and yet have I mastered it. I've tried to night on 32g for higher ohmz with out luck. If i do 28g since its thicker I can mold it much better, but to go higher ohmz dual coil on 28g is ALOT of wraps in the 1.3-1.5 area.

This guy obviously has a mod to run .05 - .08 since it looks like 24g to me.

 

[Desecrate]

Only warning I can say is on the chimney coil, is if you run HIGH watts, the coil is facing directly to your throat and mouth and will kick its ... hard with heat.