Kayfun coil screws slipping

[jcutler123]

I have built a few coils on this kayfun and it is always a hassle trying to get the wire to screw down. The wire always slips out and doesn't tighten down. I have had to loop the wire all the way around the screws sometimes just to get it to work. I have been trying to get a new coil on for 45 min and I am about the throw it out the ....ing window. This kayfun has the holes under the screws also. Is there a certain way I need to do the coil to use the holes under the screws instead of wrapping the wire around the screws? Any suggestions about the wire slipping out? thanks

 

[PapaSloth]

1). Wrap the wire around the screw clockwise, so that it gets tighter when you tighten down the screw.
2). Make sure your screws aren't stripped and are actually tightening all the way down when you screw them in.

If the screws are stripped and aren't getting tight enough, you have a problem. Let me know if that's the case, and I'll try to help you sort it out.

 

[Heavyrocker]

I have same problem,takes me a while to wrap around the screws.Wish the KF tanks had a hole in the posts.