Kayfun Lite Clone Stuck at 0.0 Ohms

[ChrispyChris]

I received my Kayfun clone about a week ago in the mail. It had been working well until last night. I go to rebuild a coil and wrap one at 1.7 ohms. Looking good so far! I then wick my cotton through the coil, still reading, boom! After I fill my tank and seal her all up, it's leaking like mad from my air hole and it won't read any resistance at all on my coil. I figure I'll rebuild and try and see if I made a mistake somewhere, nope! I rebuilt multiple times and stuck at 0.0 ohms.

Could someone help me fix this please? I'm tripping out, I just spent nearly sixty seventy bucks on a tank that isn't currently working. I normally never post about help topics, but I want this Kayfun Lite to work and I've searched and searched for an answer and am not finding anything. I would totally appreciate some help guys, I just invested money into the tank and don't want to call it a loss already. Hoping it's not too late.

Thanks,
Chris

 

[Dj Xy]

Start by checking the 2 blocks on the deck and make sure they are not touching, if they are you need to loosen the center post in the connector, re-align the blocks and re-tighten the center post while holding the blocks in line.
If that didn't fix the issue than you may have a melted insulator, loosen the center post and remove the block, and pin and check the insulators for any melted spots, and replace if needed.
Hope this helps.

 

[steved5600]

I bet the block that goes to the center post has moved and is touching the other post. The leaking if you fill from the top is normal until that flooding that occurs drips out or you vape it out. Also check the seal around the top and the cap of the vape chamber.