Kayfun Lite Plus problem

[ExCon]

So I've made a new coil for my KFL+ and checked it with an ohmmeter 5 times, it said 2 ohms. Then I put it on my Provari and checked 5 times again, it said 2.00 or 1.90 ohms. I started to vape and few minutes after I decided to check the ohms again. This time it said 1.6 and then jumped to 2.0 ohms. I checked 3 more times and it said 2.0 again. Then I put it on a table for a few minutes and checked it again - it said 1.6 for a few seconds and jumped to 2.0 ohms.
I've made a new coil - same thing happened. Is it normal? I suppose it's not... What have I done wrong? I'm pretty sure that coil is not touching the base.

 

[Joka]

Make sure the screws are decently tight maybe

 

[ExCon]

Make sure the screws are decently tight maybe

I'm pretty sure they are.

 

[Sthur]

Did you adjust the bottom pin? If it's loose the two posts with the screws will be loose and move around. Possibly they are when you vape and set it down. First thought was is coil secure on the screws.

 

[shynsly]

take a look at this post. It should be the same set up.

http://www.e-cigarette-forum.com/fo...p-kayfun-clone-post12093927.html#post12093927


The positive base is notorious for getting loose.
Good Luck!!!

 

[retired1]

Moved to Rebuildable Atomizer Systems