Kayfun Quartz Full and Nano Kits

[Silver5656]

so has anybody found a kit that fits the ehpro kfl+v2? I bought one from a local bm (with the red orings so i'm assuming its from fastech and the bm ripped me off) and it only fits my ehpro v1.

 

[Silver5656]

hmmmmm lol maybe that means that no kit will fit the ehpro kfl+v2

 

[TheoGR]

So i bought today the quartz full kit (rainbow with black orings) and when I tried to fill it from the bottom, a lot of eliquid ran through my drip tip... I put back the screw, turn it upside down and surprisingly it was full! It's not supposed to be filled from the bottom I guess...

Also should I remove my top cap and bottom cap o-rings since it has its own?

 

[Jerry J]

so has anybody found a kit that fits the ehpro kfl+v2? I bought one from a local bm (with the red orings so i'm assuming its from fastech and the bm ripped me off) and it only fits my ehpro v1.

There was some discussion about this in another thread quite some time back.

I really, really like my EHP KFL+v2. I tried to use a drop kit that works fine on my real deal KFL but I couldn't get the top to screw down. the top of the chimney bumps up against the top cap of the EHP. So on one of my EHP's I used a Reaper Mods top and it all worked out fine.

EHP changed how the top cap o-ring was held in place which is a super idea but not good if you wanna use the short chimney top. So the moral of the story is that to use a drop/nano kit you will need to change the top cap, too.

 

[Jerry J]

So i bought today the quartz full kit (rainbow with black orings) and when I tried to fill it from the bottom, a lot of eliquid ran through my drip tip... I put back the screw, turn it upside down and surprisingly it was full! It's not supposed to be filled from the bottom I guess...

Also should I remove my top cap and bottom cap o-rings since it has its own?

If you are getting juice out through the drip tip then your chimney top isn't contacting and going through your top cap o-ring. That o-ring seals the chamber where your juice is stored. Since it probably drained itself of juice I would pull it apart and check to see if the chimney is going through the o-ring.

I've never used a quartz kit but I assume that is really similar the the normal stock setup and filling should normally be accomplished through the fill hole at the bottom. I remember reading something about the o-rings blocking the fill hole with some quartz kits. While you have it drained and looking at the top cap o-ring/chimney top issue you might want to look at where the quartz o-ring sits when mounted to see if it covers the fill hole.