Kick problems with roller, 69 mod or Gus telescope

Status
Not open for further replies.

wwaaazzup

Moved On
Dec 1, 2012
92
80
This is an update as to what's been going on with my Roller by Atmizoo with.a kick in it. Brand new aw imr 18490 and a brand new kick. Basically the kick is shutting me down after only an hour and a half. When that happens if I twist the bottom of the roller a bit then it works for a minute but when I set it down and pick it up ten minutes later its shut off again or doing the sputtering thing again. I can take the kick and the battery out of the Roller and put them in my Legacy from PURESMOKER and it will work just fine for 4 more hours. I've done everything possible to make it work in the roller consistanly but so far I still have to loosen the bottom then tighten it again to make it work. And I REALLY have tried everything.
I'm just posting.g this in case anyone is having the same problem as I am.
 

BillyBenchpress

Senior Member
ECF Veteran
Verified Member
Dec 5, 2012
125
226
46
Pendleton, Oregon USA
I am having the same issues with my kicked smoktek Telescope. I think that there is some kind of conductive lube that people use, but the name is escaping me at the moment. You just a drop or two to either side of the kick and it increases conductivity



Sent from my Galaxy Nexus using Tapatalk 2
 
Last edited:

wwaaazzup

Moved On
Dec 1, 2012
92
80
Newest update to my findings with my roller and the kick. I posted earlier that it was the kick but since then I started having that problem again. I'll make it short... it was really the hot spring. Easy fix... go to Altsmoke and order the hot spring for the silver bullet. It fits perfectly and instantly fixed all issues. I ordered 2 so I would have a spare. Order it, trust me. I got into gennys and it made a world of difference and fixed ALL voltage drops.
 
Status
Not open for further replies.

Users who are viewing this thread