Knight Rider/Lava Tube and cartomizers?

[PartyNaked]

I have a new Knight Rider on its way and I have a couple questions from those that have used them. First, I usually use Kanger 2.0ohm horizontal coil cartomizers...how are these going above a standard eGo at 3.3v? Also I have some eGo Vision/StarDust coming, what voltage can these go to? Any help with your experience would be greatly appreciated. I know I need to play around by gradually increasing voltage to find the sweet spot, just looking for advice from others experiences.

 

[zer0ith]

That's the beautiful thing about having a VV there is no "best voltage" to use them that.
Start off low and with each vape keep increasing it. You will know when you go too far as the taste will go from awesome to yuck! Once you hit yuck back off the voltage to good tasting

 

[staypuffed]

i have kanger h coil 2.8 and i find that i use a different v depending on the juice usualy between 4.2 to 4.8 on the kanger i have a few stardusts on the way 3.0 not to sure how far i can go with it as of yet havent had anything good past 4.8 v

 

[therealcmac]

IMO I like to stay around 3.7 volts with the SR stardusts. If you bump it up more than that you have to really keep those wicks soaked.

 

[sunil]

Pretty sure if you are using the lower res kangers that the lavatube will self regulate and not allow the device to put out more than 3.7 even though you can still crank it to 6v. Grimm green has a YouTube video that explains this with a voltmeter to show this. I would suggest using the 2.7+ohm kangers if you want to crank voltage, that being said I find the taste really sucks any higher than 4.2v with kangers(2.7 res)

 

[zer0ith]

It depends on how low your low resistance stuff is. You can crank a 2ohm atty to 5v and it will be at 5v on the LT.

Remember its all about the 2.5amp current limit.