So guys
I bought a Kraken clone and have no idea on how to even get started on setting it up, kind of an impulse purchase lol. What materials do I need, and could you possibly link me a tutorial. Thanks
Kraken Clone, help please
- Thread starter bishop3491
- Start date
- th_trl_thread_readers 0
- Status
It should have come with some Stainless Steel mesh, some kanthal and some O-rings and a screwdriver right? you have right there everything you need to set it up
1. Roll SS mesh into a tight stick, thin enough to fit into the wick holes but not so tight that it is hard to push in
2. Cut it down so that it sits around the height of the post
3. Torch (or just burn over a flame until it glows) the Kanthal wire
4. Make 5 wraps of the kanthal on your wick (maybe go with 7 if you decide to go a dual wick/coil setup)
5. Insert mesh wick into wick hole and align the kanthal with the negative screw and positive post
6. Screw the screws down onto the kanthal wire to capture them
7. Attach to your mech mod and do a couple of dry burns to see if you have hot spots
8. Pick at wire until hot spots disappear and you have even glow over all wraps
9. Fill with juice, replace top cap, enjoy
1. Roll SS mesh into a tight stick, thin enough to fit into the wick holes but not so tight that it is hard to push in
2. Cut it down so that it sits around the height of the post
3. Torch (or just burn over a flame until it glows) the Kanthal wire
4. Make 5 wraps of the kanthal on your wick (maybe go with 7 if you decide to go a dual wick/coil setup)
5. Insert mesh wick into wick hole and align the kanthal with the negative screw and positive post
6. Screw the screws down onto the kanthal wire to capture them
7. Attach to your mech mod and do a couple of dry burns to see if you have hot spots
8. Pick at wire until hot spots disappear and you have even glow over all wraps
9. Fill with juice, replace top cap, enjoy
- Status
Similar threads
