KTS what exactly do i need to sand?

[higoukii]

So i read all these forum posts about sanding the posts connections or whatever but What exactly do I sand? I'm a visual learner lol I understand the contact point with the firing button but I don't know anything after that

So this picture for example:


Thanks in advance

 

[fullsleeve]

don't have much to add but I knew I was missing a spring on my KTS! I just couldn't figure out where exactly it went cause it wasn't there! anyway, I sanded the contacts on my smoktech natural. I did the positive connection, the connection where the tank/atty connects up top and I actually changed the firing pin from the standard to a brass bolt I bolt from home depot. it did make a difference. I always felt my kts still hits harder though.

 

[dw'struth]

Bump it up....

 

[higoukii]

^what he said
Someone must know. I don't know anything about electronics. So I can read" sand the posts" but I don't know what those are

 

[Valhalla17]

You want a smooth, clean connection on all of the contacts for maximum connectivity. I don't have a KTS but I believe the bottom button, when pressed, makes contact with that post you pictured to complete the circuit. So look at the contact on the inside of the button, the post, and the positive contact that touches the top of the battery. If those arent smooth and clean, lightly sand those. Hope this helps.