Leaking from my mechanical squonker

[DexterKBK]

I'm just now starting to use this site, but I'm having an issue with the internals leaking on the new mech squonker i received today.

It's the aleader x-drip resin squonk mod. I love the mod like crazy, but i noticed some juice on the contact bar when i was swapping batteries. Luckily the whole mod can be disassembled, including the 510!

So I've found the culprit, the leak is coming from excess juice in the 510 (due to those damn squonk pins that are cut for a flat head bit not making a seal with the pin in the mod) the juice then somehow gets underneath the 510 and runs down the positive pin right above where the contact makes, well, contact. Lol

I can't actually remove the self adjusting positive pin from the 510, at least not that i could figure out, so i can't feasibly think of any other solution than just buying a whole new 510 and doing my first vape diy project!

So, I'm sure some of you have this box, and i have 3 questions:

1. did any of you encounter this problem?

2. Anyone find a solution or know of one?

3. Does anyone know of an alternate 510 that is really available that would fit with little to no modification of the box itself?

I hope i posted this in the right place, thank you guys SO much for your help

 

[RainSong]

I don’t have that equipment but I hope you find a solution. Bump.

 

[stols001]

I don't either, but I surely hope someone who does will be along to be of help. I imagine you can probably find something that would fit, but I am surely not the person to ask. Good luck,

Anna

 

[gofishtx]

There is a forum on Squonks under the APV forum, I am sure you will get more help over there. Good luck

 

[suprtrkr]

I don't know about that machine. I don't have one. But I get some leakage there in others. It's not usually enough to bother me, I just clean it up whenever I refill the bottle. If it's leaking enough it is a problem, hopefully somebody who has the gear can help. Might try another atomizer...

 

[jfcooley]

I sqonk, but it's regulated. Can't say I've had this problem.

I'd visit the sqonk forum. Lot of users there with experience, surely someone can help there.

 

[Opinionated]

Here is the squonk forum

Liquid Feed APV Discussion

 

[DexterKBK]

Yeah i think if i can find an Atty with a better squonk pin it wouldn't be as big of a problem, thank you all so much for your responses though! I also made a post over in the bf area.

 

[DexterKBK]

Also does anyone have experience disassembling a 510? Like pulling apart the spring loaded center pin? I reeeaaally want a good look around in there but I'm not willing to break the box. But If it's a common thing that can be done to a 510 than i have no problem doing it. Probably a stupid question lol