Lemo 2 fluctuating ohms puzzle

[Miggs Beaumont]

ok this is really getting on my wick (pardon the pun) i have a lemo 2 and find it the best tank i've used yet, device wise i have a solara dna30, coolfire 4 and the i[v3 li

on the solara the coil sits at .6 ohms, every build i have done is the same and stays the same, if i put the lemo on the ipv or the coolfire it jumps between .6 and 1.4 ohms, however if i use the coolfire in volts mode it stays at .6, what can be causing this, i have tried everything from cleaning the devices to a full strip down and clean of the lemo but it always does the same thing

Miggs

 

[duc916]

When you say full strip down of the Lemo does that include removing the 510 screw and cleaning those threads, including the center block threads? Mine had a similar problem, but I found all I needed was another 1/16th of a turn of added torque, and it was cured.