Lemo 2 leaking underneath?
- Thread starter Ou2mame
- Start date
- th_trl_thread_readers 0
- Status
That's what I'm thinking. I try to pull the excess vapor out before I stop inhaling but I guess that's not the issue. It's just a minor issue, kinda bugs me. The thing is, when I rewick it doesn't do it for an entire tank.
Is it juice or more like water? If its water, its condensation. More an issue for me now that the weather is warmer.
When I refill I always take the tank off the base and use a pair of tweezers with a small piece of paper towel to clean the air chamber... And it still leaks! Lol I hate it
Mine gets this but mine is lite condensation. I use it with my istick 50 and it never goes into the hole where you connect the tank to the battery. I read somewhere on this site I believe that when filling put your finger over the mouth piece until you fill it up and close the side hole and then turn it over with your finger still on top and open the bottom air vent. Then take finger off top of mouth piece. I have found this to help a lot with any juice coming out of the air holes. Hope this helps a little.
Was hoping to find an answer to the lemo 2 leaking. Seems like mine leaks from the air holes.. I lose quite a bit of e-juice which is not the biggest problem.. It gets all over the istick 30 sticky and messy.. Hope to find an answer.. Thanks
If you're leaking that much into their air chamber, you either have a bad gasket, not enough cotton, maybe the gaskets were switched.. They are different sizes top and bottom.. Or you aren't closing their afc when you fill it.
The only time my Lemo2 leaked like that I was attempting to use the so called "pancake" wicking method. The way I look at it is this - there are two juice holes leading into the chamber, without something blocking or guiding the juice it can/will run anywhere. In my mind, unless the mod+tank is always vertical the resulting puddle of unwicked juice (result of not enough wick) will get into the chimney and down the air hole.
Thank you, George.. That is probably my problem. If it is upright it will not leak.. I will look into the wicking. I have not tried to wick it myself yet, using the wick that came with it.
With the lemo, less is more when it comes to length. It tends to like a thicker, shorter wick
I mean, that CAN happen if you're leaking but I've noticed if I go through a couple days of vaping and haven't removed the lemo 2 from that mod, I will get this too. The condensation that collects in the base ends up making it's way through the bottom of the AFC ring. No biggie.
- Status
