Lemo 2

[DaveP]

Yes it does leak a little bit from there. I haven't figured it out either...it's not a lot like 2 drops

It's not something that can be controlled with the right o-ring? Condensation is typical in the area below the coil. It's more water than anything else. juice leak is one thing. Water from the heat/cold exposure below the coil isn't something I'd consider a serious issue. I get some dew out of the air ports in my kayfun from time to time, especially if I walk outside in the cold and vape, then put it in my pocket where it gets warm and condensates.

My Lemo 2 is out for delivery this morning. Looking forward to the first use.

 

[Adam harris]

It's not a deal breaker or anything that's gonna soak your mod. Be sure to put the chimney base on and cut the wicks 3mm above the top and vape STRONG.

 

[Flt Simulation]

My Lemo 2 is out for delivery this morning. Looking forward to the first use.

Well today is MLK Day ... If your Lemo 2 is coming via USPS, your not going to see it today (Federal Holiday)

 

[DaveP]

Well today is MLK Day ... If your Lemo 2 is coming via USPS, your not going to see it today (Federal Holiday)

Yep, I realized that later on today. There's always tomorrow!

 

[DaveP]

I've had the LEMO 2 for a few days now. The stock coil was OK, but I replaced it with a 3mm Kanthal coil. After a wash and a couple of tanks of juice I can still detect a metallic taste in the vape. I may have to dunk it in the ultrasonic cleaner and let it work for a while and then re-coil it.

Vapor production is good with 80pg/20vg Hangsen juice. I'm not having any wicking problems at all. I cut the wick with the chimney off, wet the wick with juice, paste the ends them lightly to the vertical deck surface, and make sure they are just lightly touching the deck leaving room for the juice holes to work, then install the chimney and vape. I do that on my Kayfuns, also.