Leo 2ohm cartomizer - look no mods!

[sneil0188]

Leo low resistance 2ohm cartomizer

A lot of people may know all this already, but I felt so stupid having discovered it I felt I just had to share.

DON'T: attack your carto with a paper clip or tweezers and scizzors for the reason that otherwise they draw too tight. I've written off so many cartos.

DON'T: add any drops from the battery end.

DO: when filling, push the point of the nozzle of your juice bottle between the wadding and the casing and 'squirt' into the carto. i.e. fill from the outside of the wadding. Do this all the way round the outside of the wadding. It seems that if the centre of the wadding gets too wet, it swells and crushes the centre 'straw' causing a tight draw and a pain in the neck - trashed carto.

DO: blow down the battery end of the carto occasionally, you should be able to see daylight down the centre. NO PAPERCLIPS.

Loose draw - tons of vapour!

 

[tmcase]

If you are getting too hard of a draw you might have the carto/atty too tight on the battery. Try unscrewing the carto/atty just a little until the draw is right and still produces vapor.

 

[Bdbodger]

Do they have a 2ohm cartomizer for the leo ? The ony ones I know of are the 4 ml one that test out at 3.4 to 4ohms . Or did you mean the 2ohm cartos for 510 made by boge .

 

[sneil0188]

Yes it's advertised as LR

 

[evilfrog]

I believe a couple vendors got LR Leo cartos when these came out.
I have run a paperclip up the battery end when my Leo cartos have clogged. It must be done delicately or the carto will be destroyed, but it does loosen up the draw. I haven't needed to do this recently... maybe I've just gotten better at filling them.

 

[sneil0188]

maybe Boge have got better at filling them