Little Help

[strckn]

I recently purchased a eliquid, apparently freebase that has this information: "Not for sub-ohm use."
It caused me a little doubt, as I always use liquids similar to this configuration and I have never seen this type of warning.
Is it safe to use this liquid with my setup?
It is a Z200 starter kit that comes with a Geekvape Z Sub-ohm tank.
Thanks!

 

[Bingbong]

3% what’s your norm? Might lead to a chain vape or a coil kill on intensity but will work. Good luck!

 

[strckn]

3% what’s your norm? Might lead to a chain vape or a coil kill on intensity but will work. Good luck!

It's usually 3mg. I'm more concerned about whether this could cause any health problems, If it's only chain vape or coil killer I don't mind.

 

[Bingbong]

Lower ohm higher wattage usually prefers lower nic level.

 

[GeekyGeezer]

Suspect it may be nic salt instead of traditional nicotine since I've seen that advice provided at times. Not sure of any health issues other than a chance of getting nic sick for a short period of time.

 

[Bingbong]

I used 55mg mic salt in a 1.6 ohm aspire unit. I use 6 mg in a Vaporesso high wattage unit, I prefer 40w on a .4 coil. Day n night difference.

 

[strckn]

Suspect it may be nic salt instead of traditional nicotine since I've seen that advice provided at times. Not sure of any health issues other than a chance of getting nic sick for a short period of time.

It says FREEBASE. I don't think it's nic salt.

 

[Bingbong]

Welcome strckn.

 

[Bingbong]

No matter what it’s made of, faster it’s induced more it will hit ya. Voltage And percentage play a huge difference in how you feel per hit.

 

[strckn]

No matter what it’s made of, faster it’s induced more it will hit ya. Voltage And percentage play a huge difference in how you feel per hit.

I actually didn't feel any difference from other liquids that have the same characteristic, what really intrigued me was the fact that it contained this information about "Not for sub-ohm use". Since I always used this kind of liquid in Zeus Z Tank.

 

[Letitia]

I recently purchased a eliquid, apparently freebase that has this information: "Not for sub-ohm use."
It caused me a little doubt, as I always use liquids similar to this configuration and I have never seen this type of warning.
Is it safe to use this liquid with my setup?
It is a Z200 starter kit that comes with a Geekvape Z Sub-ohm tank.
Thanks!

View attachment 1017810View attachment 1017811View attachment 1017812

PG is too high. For that style of atty 70 vg 30pg is the norm. Your juice is 30vg 70pg.
If you bought the juice locally and its not been opened the shop may let you trade it out.

 

[Bingbong]

I used less juice on 55 mg 1.6 ohm 5w vs .4 ohm 6mg 40w.

 

[Bingbong]

Leticia I wish you were my neighbor in Philly, I love citrus and fruit flavors. Hahah.

 

[strckn]

PG is too high. For that style of atty 70 vg 30pg is the norm. Your juice is 30vg 70pg.
If you bought the juice locally and its not been opened the shop may let you trade it out.

Got it. Makes sense. But if I unfortunately have already used it. Would there be any problem continuing to use it?

 

[Letitia]

Leticia I wish you were my neighbor in Philly, I love citrus and fruit flavors. Hahah.

Letitia lol
PM me if you want to chat about diy so we don't clutter this thread.

 

[Bingbong]

Yep 70vg30 pg norm here low nix level. Normally prefer 60/40 or 50/50. Everything is a science. Coil wattage and whatnot.

 

[Letitia]

Got it. Makes sense. But if I unfortunately have already used it. Would there be any problem continuing to use it?

It always helps us give advice/answers when you ask about tanks or juice you post your average wattage, af (airflow), and ohms. If its working for you then yes keep using the juice.

 

[ShamrockPat]

3% what’s your norm? Might lead to a chain vape or a coil kill on intensity but will work. Good luck!

Where on that entire bottle did you read 3%. It's NOT there.

@strckn like Letitia mentioned, the PG is high, so use more cotton in the tails so it's not as prone to leak

 

[Letitia]

Yep 70vg30 pg norm here low nix level. Normally prefer 60/40 or 50/50. Everything is a science. Coil wattage and whatnot.

More like higher vg % performs better with sub-ohm coils used at higher wattage. If the coil is 0.9, lower wattage & more af restriction the higher pg will perform fine. That being said stock coils/wick used as intended the coil generally lasts longer. Under or overpowered coils for some reason beyond my understanding don't last as long and flavor isn't as good tho not bad at all in my experience.

 

[Letitia]

Where on that entire bottle did you read 3%. It's NOT there.

@strckn like Letitia mentioned, the PG is high, so use more cotton in the tails so it's not as prone to leak

Under freebase on label.