it's hard to convey how small this is. I have short thumbs but it always looks smaller in person. there is a thread on these on the same page. it works great and the battery lasts a long time. very solid. 

Just noticed this thread. I didn't go through all the 6106 messages, so I don't know if this has been posted here yet: Mini Volt by Council of Vapor | Compact 40w Box Mod - ECIG CITY
Mini Volt by Council of Vapor, 40W and 1300mAh built-in battery. I highly doubt you can get anything smaller than that, that's usable down to 0.2ohm range![]()
Arnold, the dimensions are 35mm * 22mm * 56mm, yes? I'm contrasting it to another tiny device I have (just for fun).
33mm * 22mm * 69mm (mine).
WOW! The Mini Volt is TEEEEEEEEEEENSY!
Wow. That IS small, @Arnold Ziffle . And I can honestly say that I don't have anything that small.![]()
Arnold, the dimensions are 35mm * 22mm * 56mm, yes? I'm contrasting it to another tiny device I have (just for fun).
33mm * 22mm * 69mm (mine).
WOW! The Mini Volt is TEEEEEEEEEEENSY!
too easy
i almost picked up a CC mini volt yesterday, wow, that volt is smaller than i pictured it in my mind.
My Kangside mini 25w (18350) works great, except for one thing. The screws that hold the bottom plate on backed themselves out. I thought the battery was too low because it kept rebooting. Then I noticed the screw issue. Tightened them up and it works fine. I'm nervous about tightening them too much and stripping out the aluminum channels.
I've got some superglue, liquid and gel. If it happens again, I might try that.A little Loctite works wonders for this.
Easy, like a Sunday mornin...
![]()
You, sir, are a true tootle-dripper. The HH 357s are magnificent for tootling with great flavor!