Well, guess what, I want to purchase all that is needed at the same time even if they are different orders. I need your guidance on what to buy in terms of the wick and wire needed. Thanks in advance for your recommendations
Hey D, I suspect you've been using Kanthal or Nichrome in your attys for a while now and I'll bet it's 32ga Kanthal. I'm just guessing here. 30ga is a little thicker than 32 and easier to work with but will require more wraps to get to your preferred ohms. 28ga is even thicker and easier to work with but again will require even more wraps. 26ga even thicker etc...and you might notice a slower ramp time, meaning it will take a little longer for the coil to heat up. I use 2 twisted 28ga kanthal and there is a slight ramp up time. Usually the first 2 vapes have little flavor and vapor but by the 3rd vape it's great and that applies to if you set the mod down for awhile and come back to it. Once the coil gets warm then you won't notice the ramp up time. You probably wouldn't anyway with a single wire coil. Just a little education on wire.
Wick...Koh Gen Do Japanese Organic cotton found at Amazon or Sephora for around $12 for 60 pads, ebay probably has it cheaper. For Rayon, DavidOck said it best. In my experience rayon wicks faster but cotton holds more juice. Cotton taste funny for the first couple of vapes and then it's great. Rayon tastes great 1st vape. Both have a learning curve...how much or how little to use. You'll figure it out. There's your education on wicks.
To make coil making easy, I would recommend a set of these
http://www.coil-master.net/product/coil-master-coiling-kit-v4 You cold just use screwdrivers or drill bits but then you wouldn't know the inside diameter of your coil and this is important because some attys might work best at 2.5 ID and some at 3.0. There's a little info about building coils.
Good luck and you know we are here to answer any questions that you may have when you start building.
I bet it weighs a ton not to mention it's .... ugly. 
