Looking at tanks, not sure what cartomizers to get

[Nailz]

Right now, I use mainly clearo's, but I can't fully use my VV device due to clearo's burning at higher voltages, so looking at getting into tanks, also I intend to buy replacement carto's too, but don't understand enough about them to make a decision on which to get, so maybe the good people of ECF can explain the differences in them.

The choice I have is, single or double coil, and then either 1.5ohms, 2.0ohms and 2.5ohms.

I want to be able to use the full voltage at times, and get the best flavor/vapor I can, so what would be my best option to choose on the carto's?

 

[D. Waterhouse]

What device are you using?

 

[Nailz]

V4L DAV VV, goes from 3.2 to 4.8 volts.

 

[Are Jay Maytuh]

I just recently acquired a cartotank. I am still using the same flavor, and original cartridge that was in it a few days ago, but i have 5 smoktech DCTs that should arrive today, while im out taking care of things in the city, so Ill see them around 5pm tonight hopefully.

 

[Rocketpunk]

Right now, I use mainly clearo's, but I can't fully use my VV device due to clearo's burning at higher voltages, so looking at getting into tanks, also I intend to buy replacement carto's too, but don't understand enough about them to make a decision on which to get, so maybe the good people of ECF can explain the differences in them.

The choice I have is, single or double coil, and then either 1.5ohms, 2.0ohms and 2.5ohms.

I want to be able to use the full voltage at times, and get the best flavor/vapor I can, so what would be my best option to choose on the carto's?

I've used Smoktech 2.0 ohm single coil cartos with 1 factory laser-punched hole since I began using cartos and they have worked beautifully.

All of my juices are 60/40 pg/vg (except Boba's), and there has been zero percent flooding or "wicking" issues. The only time I self-punch a second hole is for Boba's.

I guess I have been blessed with good priming skills. My coworkers use this weird suction action by placing their tanks and cartos into the palm of their hand and sucking. It kinda works but it always ends up getting juice in their mouth. I just "drip and flick" (shaking it like a thermometer after 6-19 drops) until juice comes out of the factory-punched hole. I never seem to have flooding issues or burnt cartos... Like I said, I must be blessed...

Edit: I never vape above 4 volts unless I have to use a dual coil carto. I stick between the 3.8 volt - 4.0 volt range.

Sent from my KFOT using Tapatalk 2

 

[D. Waterhouse]

Single coil, 2 ohm,your battery won't handle the amp draw of a dual-coil and 2 ohm will give you the best range of watts. If you find yourself at the top or bottom of your voltage range try a different resistance carto.