Looking for a suitable tank. Help please!!

Status
Not open for further replies.

Scr81

Full Member
Oct 26, 2014
36
9
I've got a vamo v6 and I've been getting along great with a dual coil build on my igo-m at around 1.0-1.2ohms. I love the huge air holes and flavour etc etc. For me this tank is virtually indestructible. The only issue I have is the amount of dripping that I have to do.

I drive a lot and it's not lasting long when I'm in the car without needing to refill.

What I'm looking for is a rebuildable that will have the same simple build but is secure when driving and has a tank to hold a few mls of liquid.

Also I'm a klutz so I want a tank that has a 100% stainless steel tank on it. No glass. I've dropped so many glass tanks on my kitchen floor I can't be dealing with glass anymore!

I hope you guys have got some good suggestions for me. Also any pics of the the tanks would be greatly appreciated as I'd like something that looks good on the vamo.

Thanks!
 

roxynoodle

Unregistered Supplier
ECF Veteran
Jun 19, 2014
15,344
37,213
Ohio
An EHPro kayfun would work. Or an authentic, of course. The Rose v2 comes with a SS tank section as well.

You can get a SS for the Erlkonigin, or some of the clones have one.

You can also buy a SS tank for the Taifun GT.

Of those, the kayfun and taifun are easy builds. The Erlk is finicky to wick, and the Rose can be time consuming.
 

pls0138

Senior Member
ECF Veteran
Oct 2, 2014
226
242
New Jersey
If you weren't against a glass tank I would say the eleaf lemo. Huge airflow and no leaking problems, for me at least. Your best bet would probably be some sort of kayfun, unfortunately you aren't going to get the big air flow you are used to from a dripper or what you would get with a lemo.
Just curious, when you've broken glass tanks in the past is it because you have dropped them or because you had them laying on a table on their side and they rolled off? If it is the latter, then I would seriously consider a lemo, it is a glass tank, but since you can remove the bottom 510 base, you can stand it up right on a table.
 

Scr81

Full Member
Oct 26, 2014
36
9
I've since got myself a clone from hekvapor of the big dripper and it's been a revelation! I'm in love what can I say...

It's perfect for what I need. It took a bit of trial and error to make sure the vacuum worked properly but it's brilliant. If I could've afforded the original I would've but at £100 it was too steep.

The clone I've got is 99.9% perfect. I'd recommend it to everyone. Building coils in it isn't too difficult and the fact that I have a dripper with a tank has made my day.

I'd recommend people check out Rip Tripper's review on YouTube. The clone I have is amazing. :) Thanks for your help guys.

ImageUploadedByTapatalk1418077766.053370.jpg
 
Status
Not open for further replies.

Users who are viewing this thread