Looking for advice with dripping setup

[BAMvaping]

OK based on the responses here and my research I think I have come to a conclusion...

Trident clone w/ pyrex drip tips. Now I just need to get some kanthal

http://www.fasttech.com/products/1418702
http://www.fasttech.com/products/1522600

 

[LEDBETTER122]

Before You order, I must warn that it take around 2-4 weeks to get things from fast tech.

 

[cjmazzotta]

Can't go wrong with a nimbus. Cheap and works great!

 

[BAMvaping]

Thanks, LEDBETTER, I didn't order! I found a vendor here in Dublin with the Trident clone for a tad bit more + gas but much more convenient!

 

[BAMvaping]

VAPEMAIL! The MVP v2 is great and I finally lost my mod virginity! Tiniest defect on the bottom aluminum where it is bowed slightly so has a tad wobble when stood upright, but I have no problem storing it on its side. Right now I'm going through my various juices trying different wattage settings to see where the sweet spots are and LOVING IT!

 

[XrisM]

Ah yes I concur

 

[wedoitall]

VAPEMAIL! The MVP v2 is great and I finally lost my mod virginity! Tiniest defect on the bottom aluminum where it is bowed slightly so has a tad wobble when stood upright, but I have no problem storing it on its side. Right now I'm going through my various juices trying different wattage settings to see where the sweet spots are and LOVING IT!

I'm pretty sure I read that you can fix the wobble when stranding he MVP 2 up. I'll do some reading today and report back, as I would like to have a fix for mine.


Sent from my iPhone using Tapatalk

 

[BAMvaping]

I'm pretty sure I read that you can fix the wobble when stranding he MVP 2 up. I'll do some reading today and report back, as I would like to have a fix for mine. [/URL]

The wobble is USUALLY cause by a protruding on/off switch at the bottom for the input/output charge port. In my case it isn't sticking out but rather there is a tiny bowing to the aluminium. I don't think it can be fixed and I sure as hell don't want to take a rubber mallet to it.

 

[LoveVanilla]

You can also buy 50 of the premade coils (nichrome + silica) for $6 from Fasttech. They have even cheaper but the silica quality doesn't seem good. In particular, the Goonk premades seem to be good quality. Then just unscrew to the remove old coil, mount the new and retighten.

There's some negative press on silica shredding as it degrades. I just replace every day or two to avoid any degradation. Easy peasy.

 

[JoeDerty]

I love the Trident V2 clone $20 Trident V2 Clone - YouTube