Looking for another RDA

[CasketWeaver]

I'm sure someone has some ideas out there that would match this profile - I'm looking for an rda that is at minimum 22mm diameter - has the same inner chamber size of the Trident V2, but has larger holes in the posts. Any suggestions? I was looking at the Zenith V2 for sure - the post holes are MASSIVE in appearance, but can they fit 2 parallel coils built out of 24G wire? I didn't get a good look at the inner chamber though.

 

[Shields42]

My zenith holds two 26 AWG wires, and quote well, if you like ivs got some 24 AWG laying around, I could test it for you in my zenith, but the zenith v2 is a champ of an rda.

 

[Blackboar]

What about a Helios or Igo-M? They have the large positive post/block that has 2 holes for the positive lead. Both seem very able to throw clouds, but neither has a really small chamber, so flavor may be a bit muted when compared to a Trident v2.

 

[CasketWeaver]

I looked at the Helios - its if memory serves me - a 20 or 21mm atty. The holes are small compared to the Zenith. Just look at the Zenith shields, Parallel coils are technically dual coils wrapped in a single formation. I was wondering if it could hold 4 24 AWG coils. That's the whole shennanigans. I need more heat is all. I got a Trident V2 and I hate it - see my post about it. But yeah an IGO M... I looked into it and the chamber looks HUGE.

 

[Shields42]

Probably would have to drill out your post holes for 24 AWG. That's a lot of wire dude.

 

[CasketWeaver]

Yeah, I kind of figured. Looks like I may have to build my own atty. Build it for crazy low AWG wire is all. Weld the negative posts to the deck. Craft a good solid positive pin out of either copper or gold plated copper. I'll figure something out.