loranns at lower ohms?

Status
Not open for further replies.

blueguell

Full Member
Mar 7, 2014
17
7
Alabama
I have been mixing with TFA flavors for the past 6 months with really good results, however I decided to try some loranns flavors just for the heck of it. My first attempt was a root beer float. I mixed 2 ml of root beer 1 ml of Bavaria cream and 15ml base. Smelled great so I loaded up my kayfun at .9 ohms and took a pull. As I exhaled and analyzed the flavor I was very unpleasantly surprised. Usually juices pretty much taste like they smell, but this one didn't. There was no hint of root beer or cream, just burnt. Kind of like a nutty burnt flavor.

I forgot to set my alarm last night and woke up late for work this morning so I had no time to switch flavors and was stuck with this terrible flavor all day. Had a rough day at work and even ended up bumming a smoke from someone just to avoid vaping that terrible juice (which says a lot because I hadn't had a cigarette in about 3 months and hated my last one).

Any who, when I got home I cleaned out my kayfun mixed up some black cherry and chocolate (both loranns), built a new 1.1 ohm coil and am now vaping that. It's not bad, but I still am getting a little bit of that burnt nutty flavor.

Never had this experience before with tfa flavors, anyone else have this experience with loranns?
 

dannyv45

ECF DIY E-Liquid Guru
ECF Veteran
Verified Member
Apr 12, 2013
7,739
8,424
New Jersey
www.e-cigarette-forum.com
May want to rebuild the kayfun as the wick is likely saturated with the old flavor. I don't much like the loranne flavors and would use TFA, hangsen or inawera flavors instead. Loranne flavors are just to inconsistant. Some are to weak others to strong and others just plain awful.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread