Lost Silica In Atomizer

[weeble]

I was dry burning and cleaning my atomizers earlier and lost the silica parts that go on top of the coils. Is there anything I do to fix this? I tried using one and it started flooding and leaking fluid. I just got some ekowool with organic cotton inside to start using RDAs. Would that work? Any help will be greatly appreciated. Thank you!

 

[crxess]

Don't know what coil you are working with or what size Eco wool you purchased, so maybe - maybe not.

You could pull from a cotton ball and roll a small flavor wick.

 

[DlyDragger]

I'm assuming a protank maybe? Did u lose one or both of the flavor wicks? If so, either replace the coil until or go but some 1mm silica and replace it. Definitely need more info here.

 

[State O' Flux]

Don't know what coil you are working with or what size Eco wool you purchased, so maybe - maybe not. You could pull from a cotton ball and roll a small flavor wick.

crxess' suggestion is your easiest, fastest repair. You must have a minimum dimension of wick material to fill the void in a coil head... or you, as you've discovered, will have flooding problems.

 

[weeble]

It is the atomizers for the atomizers for the EVOD / Protanks and I did loose all of the flavor wicks for them.

 

[crxess]

One more tip - Replace cotton, if used, any time you clean the coils.(can not burn clean)

1mm silica wick is good to have in reserve. Can be used for flavor wicks and folded for thicker wick applications in other devices.