I'm just getting into rebuildables and I want to try a dual coil build with micro coils on a nimbus clone. I want to get the the ohms reading around .65 to .75. I'm using a Z max mod. Will the mod allow me to do this or will it refuse to fire at a low resistance. Am I better off doing a single coil build until I can pick up a mechanical mod?
Low Ohm Build
- Thread starter EdwardOrn26
- Start date
- th_trl_thread_readers 0
- Status
not familiar with the Zmax... is it a regulated/chipped mod?? or is it a mech?.... if its a regulated mod then I would doubt that it will allow much less than .8 ohms....
If you do pick up a mechanical mod to run your not unreasonable coils, then make sure you revisit your apprentice skills and measure your coils before you fire them and use batteries that can handle the current.
Your vamo is better used as something with higher resistance coils - i'll say 1.5Ω and then you can power them. You will get a regulated = safe vape and you can blast the crap out of them.
If you like.
T
Your vamo is better used as something with higher resistance coils - i'll say 1.5Ω and then you can power them. You will get a regulated = safe vape and you can blast the crap out of them.
If you like.
T
If I do that I'm I better off doing a duel coil build with more wraps to increase resistance or go to a single coil witch will give me more ohms. That's with using the Variable volt Mod. I have the general knowledge of ohms law but not the knowledge of witch will give me a better vape
Dual coils halve the resistance which is measured in Ohms, so i'm not really sure what the question is.
T
For a dual coil on a regulated device you would need each coil to be 3 ohms to have your Z max to read 1.5 ohms. That's a lot of wraps on each one. I go with single coil on my regulated devices, but that's me.
Make one coil is my advice. because to run duals - the general idea it they have to be the same, identical in every way.
Before you all jump on me about different gauges of wire for each coil that will work just fine and how you balance them and ...c'mon!
T
Before you all jump on me about different gauges of wire for each coil that will work just fine and how you balance them and ...c'mon!
T
I wasn't trying to jump on you. I was just trying to explain the same thing you said...I didn't even mention wire gauge.
- Status
Similar threads
- Locked
