Low Res with HV

[blackwater]

Does HV vaping ruin LR attys. New to HV. Sorry if this is obvious.

Thanks,

Chris

 

[Diablo]

Yes it will pop them faster because you are pushing more amps. Its best to keep your amps lower than 2 when you go above it you risk popping it not to mention you are putting a strain on your battery. I have gone up as high as 2.5 amps but it will shorten the life quite a bit. Try getting a higher ohm atty it will handle it much better.

 

[blackwater]

Thanks. Learned the hard way I guess. Brand new atty only 2 puffs in and it's shot. Hahaha.

 

[Diablo]

check here Ohm's Law Calculator to figure out which attys to try. Plug in 2 of the numbers and it will calculate the other 2. Try to stay under 2 amps to be safe but you could push it a little beyond it.

 

[blackwater]

Thanks. Great resource.

 

[Grumpus]

In general we always have 2 values. Resistance and voltage. V^2/R=Power.

I do vape lr at HV. My LR's pull 24W @ 6V. For me i haven't a noticed a huge enough difference between vaping at 3.7V vs 6V. On my 3ohm carts there is a much bigger difference.

For clarity. I have "normal" 3 ohms carts and dual coil LR carts and single coil lr carts. Both LR carts are 1.5 ohm.

 

[SkeetS]

Here's my 2 cents...
Use the LR's on 3.7 and regular at 5V...i think this way you can be safe (correct me if i am wrong)