Magneto&Pulse-G want lower resistance!

[surfingrice]

Just got my first mech mod yesterday. Smoke Tech Magneto coupled with a Pulse-g. Built it dual coil with cotton wick. Came out to .4 ohms. Made the switch to 100% VG as well. Needless to say its putting out some heavy vapor. Was thinking about drilling out the air holes on the side of the Pulse to a 1/8'' hole. Any thoughts? Also wanted to know what I can do to bring it down to about .2ish ohms.

Thanks for any suggestions!

 

[State O' Flux]

Just got my first mech mod yesterday. Smoke Tech Magneto coupled with a Pulse-g. Built it dual coil with cotton wick. Came out to .4 ohms. Made the switch to 100% VG as well. Needless to say its putting out some heavy vapor. Was thinking about drilling out the air holes on the side of the Pulse to a 1/8'' hole. Any thoughts? Also wanted to know what I can do to bring it down to about .2ish ohms.

Thanks for any suggestions!

.125" (3.18mm) is pretty large for air holes. You might want to step up gradually, if you have the drill bits.

Lower resistance = thicker wire, fewer coils. Use the "Steam Engine" calculator found at the hyperlink in my sig line to "virtually" build coils.

 

[surfingrice]

Thanks!
Already saved that link to my toolbar. But i had some trouble with it building a single coil on my phoenix 2, didn't exactly come out the way it said it would. Any good recommendations for sites with resistance to air hole ratio?