Maybe need help, at least a explanation

[Theamazingspicmo]

Hello, I recently upgraded from a Itaste VTR to a Jellyfish mod with the Arctic Sub ohm tank.
I had a juice in the tank that was 70vg/30pg at first and seemed fine, no issues at all vaping at 50w on I believe .2ohm coil. When that juice was done, I switched to a new coil and a 50/50 mix and now have a decent leak going on. Still decent vape and flavor, but getting decent bit of juice as well. Everythind seems fine when reading/looking at my display compared to when I had the 70/30 in there, so could it just be the juice is too thin? Idk, figured I'd ask.

 

[DingerCPA]

Welcome!

My gut says that something's a touch loose somewhere - coil not completely seated (should be snug, but not over-tight). Maybe the base is not quite tight enough? Maybe a damaged o-ring?

I can't imagine that 50/50 is too thin....

 

[ryanrokz]

Hey spicmo!

I would say that you have a broken/loose o-ring on your tank. I use a KangerTech sub mini and an aspire atlantis, both of which i have found that using a juice below 80vg/20pg will either cause popping or a slight leak when the base gets hot. With sub-ohming I would just stick to higher VG juices.

Happy vaping!