Mech MOD ideas for at work?

[David1975]

I'm just getting into Mechanical MOD's and I've picked up a Caravela and have been using it with a Kick 2 around the house. I love it, but now, I'm looking at get a "beater", something I can use all day at work (welder/mechanic) and wont care about how dirty it gets or if I scratch it up. I would like something telescopic, capable of using a kick and with a floating center pin..... I was immediately drawn to a K100, except I've already got a custom holder in the truck and at work that can only hold 22-23mm. I'm hoping someone with more experience/ been around the block , might know of a MOD fitting these requirement. I basically just want something 22-23 that I can alternate between 2 different kayfun's (not clean at work to refill), have the 510 flush on top for strenght, use the Kick and then change quickly from battery to battery including different battery sizes if need be without a hassle.... ex-smaoke quitting so I can't have the boss see me "playing with it" when the battery dies or I empty 1 kayfun and switch over to the other. I know what many might say.... go get an Elvt, there tuff. Ya, have gone through 2 of them so far, not sure if it was me/my place of work or faulty devices. I thank anyone reading this for their input.

 

[Xaiver]

If you want something that can take a beating and keep kicking, you may want to look into altsmoke's silver bullet or omega. The silver bullet fits an 18650 and kick with a sleeve or 18500 and kick without the sleeve.

They're made from aircraft aluminum. While I've never tried to run my bullet over with my car, I have no doubt that it would be fine.

They're not telescoping, and they're a little more pricey than the China mods, but the quality of this device speaks for itself.

Give them a glance, they may not be perfect for what you want, but that's my suggestion.

Cheers

 

[steved5600]

I have a magneto and think that could be your answer. But to use a kick you have to either use a smaller battery or get the optional extension tube for it. What ever you get just don't get a #19. I have one and i've made all the upgrades to it and it still misfires. I've also run into that problem with the K10x mechs. Oh just remembered they make a Kick kit that has a module that screws on to any mech with a 510 connector that is like 1" tall and houses the kick inside it. I've got two of them and they work well on mods that don't accept the kick board. Think I got it from Mad vapes.